Bo Bunny – Love letters Step by step with Rachael Funnell
- Bo Bunny Love letters – Banner paper
- Bo Bunny Love letters –Flutter paper
- Bo Bunny Love letters –Brads
- Bo Bunny Love letters –Combo stickers
- AC thickers – Masaic (light grey)
- Black Green Tara rosebuds
- 9 assortment of flowers – Prima & Kaiser craft
- Washi Tape
- Kasiercraft – Wooden flourish Vine
- AC- Cardstock – light grey
Materials to create the background
- Glimmer mists – Pale blue, pale pink & fuchsia pink.
- 6×6 CW – Wedding ring template
- Modelling Paste
- KC- number stamp
- Black ink
- Washi Tape
Step 1. With the CW – Wedding ring template add some Modelling paste to the right corner a little to the top left & then half way down the centre.(as shown)If you can, dry using a heat gun as you can get this bubble affect
Bubble affect with heat gun
Without using heat Gun
Next spray some pale pink glimmer mist at the top right then spatter a few times, also spatter with the fuchsia pink. Spray & splatter at the bottom left with the pale blue. Add a couple of washi tape strips & stamp with the KC – number stamp.
Step 2.From the combo sticker sheet attach the love every Inch sticker just above the washi tape, then cut a 23cmx5cm strip from flutter paper, inking the edges in teal & attach with foam/mount squares.From the reverse side of flutter paper cut a 15cmx13cm rectangle round the corners, ink all edges with teal & attach. Then attach your photo with foam/mount squares. Then attach the frame sticker with foam/mount squares to your photo.
Step3. Cut out from the reverse side of banners paper the you’re my favourite banner & attach with foam/mount squares. Then dab some modelling paste over the KC- Flourish Vine, once dried stamp this with a Script stamp & attach this vine, then add your title.
Step 4. Fussy cut out the hot air balloons from 1 of the combo stickers & attach with foam/mount squaresadd a few others stickers, then add a few of those BB- Brads.
Finish up. By adding a cluster of flowers, 3 of the GT black rosebuds peeking out from the top of the banner & the others throughout the cluster. Inking the edges of cardstock black & you’re done. <3